Tuesday
Jan262010
Equipment Cleaner RD-34
All Purpose product for removal of Water Hardness, Photoresist, and Metal Salt Deposits
Equipment Cleaner (RD-34) is an all purpose product for removal of water hardness, photoresist and metal salt deposits from chemical processing equipment. Specifically developed for the Printed Circuit Board and Chemical Milling Industries, it will safely clean any spray equipment without damage to any metal or plastic. It is important that you read the Disposal instructions before using this product.Equipment Cleaner (RD-34) may be used at any temperature the equipment can safely handle, and may be reused until all the capacity is consumed.
Equipment Cleaner (RD-34) is a proven product that cleans:
- Dry film developer residues
- Cleaner residues
- Dry film stripper residues
- Etcher residues (ammoniacal, cupric, ferric)
- Solder stripper residues
Equipment Cleaner (RD-34) will typically clean most spray equipment, and rinse chambers, including clogged nozzles (without removing the nozzles), in less than 30 minutes. It is a one step process, and only needs to be flushed with tap water before the equipment is ready to be recharged. It is so safe that Equipment Cleaner (RD-34) may be left circulating overnight, if desired, for extremely thorough cleaning.
MAKE-UP:
25%-30% by volume: for the first cleaning, because of high soil loading. Lower percentages (10%) may be used when equipment is cleaned regularly.
OPERATION:
May be used unheated, but cleaning times may be excessive (over two hours) depending on deposit age and composition. May be heated to as high as equipment will allow.
- Polypropylene - 160º F / PVC or Polyethylene - 130º F
- Stainless & Titanium - to the boil (> 212º F)
SAFETY:
Equipment Cleaner (RD-34) is highly alkaline but contains no hazardous ingredients other than the alkalinity. Contains caustic potash (lye) and can cause severe burns to skin and eyes. Wearing safety goggles or a full-face shield is MANDATORY. Consult Material Safety Data Sheet for further information.
DISPOSAL:Equipment Cleaner (RD-34), as supplied, may be discharged into most sanitary systems. However, during use Equipment Cleaner (RD-34) may pick up heavy metals which must be removed before the product can be discharged. Use heavy metal precipitants, which may then be filtered out. Never dump Equipment Cleaner (RD-34) into the heavy metal clarifier, it will prevent separation of heavy metals. Put the treated Equipment Cleaner (RD-34) into waste water after the clarifier. Dispose of in accordance with Federal, State and local regulations. Contact your RD Chemical representative for further information.
PACKAGING:
Equipment Cleaner (RD-34) is available in 5, 15 and 55 gallon drums.
tagged products in Printed Circuit Board Fabrication