MicroClean™ MV (RDZ-1995)

MicroClean™ MV (RDZ-1995)

DESCRIPTION:
A strong deoxidizer for removing extreme oxides formed by high temperature on Nitinol, and other Titanium alloys. MicroCleanTM MV is strongly inhibited from attack on the metal, and will cause negligible metal attack, but usually will clean up essentially any oxide level in a short time (1-5 minutes) and metal loss within this time is minimal.

SPECIFICATIONS:
Density:  1.14 g/ml, 9.5 lbs/gal
Flash Point (TCC):  None
Appearance/Odor:  Clear, colorless liquid/mild odor None
VOC Content (EPA Method 24):  None
pH:  <1

EQUIPMENT:
Use/store only in plastic containers, will attack most metals and glass.

INSTRUCTIONS:
Concentration: 100%
Temperature: Room Temperature or higher ; Higher temperatures result in more rapid deoxidation.

Ideal Operation

1. Immerse parts in MicroCleanTM MV solution, agitation will speed oxide removal
2. Soak for 1-5 minutes
3. Rinse with water
4. Rinse with 99+ % Isopropyl Alcohol
5. Electropolish in ElectroPolish Ti2 (RDZ-1676) or ElectroPolish NF (RDZ-2064)
6. Deionized water rinse

SAFETY:  Contains strong acids, use with caution, do not allow to contact skin, or eyes. If contact occurs, wash immediately with cold tap water. Consult Material Safety Data Sheet for further information.

DISPOSAL:
May contain dissolved heavy metals when spent, depending on alloy being cleaned, which must be removed before disposal. Also contains Fluorides, which are restricted in some jurisdictions. Dispose of in accordance with federal, state and local regulations.  Contact your RD Chemical representative for further information.